B-Flex Gimme 5 series is extremely high quality heat transfer iron on PU vinyl, with a super soft matte finish for shirts.
Sheets are 12"x15" each.
Can be used with ANY CUTTER!
-Cricut
-Silhouette
-Scan N Cut
-Roland
-Graphtec
-All plotters/cutters
Application Instructions (heat press)
• Cut in reverse (Mirrored)
• Weed excess material
• Preheat garment for 2-3 seconds
• Apply design at 300°F (With Teflon Sheet)
or 285 without Teflon sheet
• Use medium pressure for 5-10 seconds
• Peel carrier hot
Application instructions (home iron)
• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 5-10 seconds
• Peel carrier warm
LAUNDERING:
Wait 24 hours before 1st wash
Machine wash warm or cold / mild detergent
Dry on normal dryer setting
Do not dry clean
CUTTER SETTINGS:
Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.
Cricut:
Blade: Standard
Setting: Iron-on
Silhouette Cameo settings:
Blade: Standard, 3
Material: Heat Transfer, Smooth
Speed: 8
Force: 4 - 6 (depending on blade sharpness, start at 4 go up as needed)
Scan N Cut:
Blade: Standard, 2
Cut Speed: 1
Cut Pressure: 1
Roland GS/GX-24:
Blade: 45°
Gram Force: 80-90
Offset: .250
Speed: 25-50 cm/s
Graphtec:
Blade: 45°
Gram Force: 8-9
Tool: CB09U+0
Speed: 30 cm/s
Specifications:
PU Composition • Pressure sensitive backing • Matte finish • 45°/60° blade • Can be layered